MPCLII Packet Reference Manual

Defining the Supply Setup Packet –––––––––––––––––––––––––––––

Use the supply setup packet (B) to select supply type, ribbon, feed mode, supply position, and cut position.

Syntax {I,B,supply_type,ribbon_on,feed_mode, supply_posn,cut_posn p}

B1. B

Supply Setup Packet

B2. supply_type Supply Type. Options:

0Black mark stock

1Die Cut/aperature stock (9446/1460)

2 Non Indexed stock (9494)

B3. ribbon_on

Options:

 

 

0

Ribbon not installed

 

1

Ribbon installed

 

2

High Energy Ribbon (9446)

B4. feed_mode Options:

0Continuous operation (9494/9490/9446)

1 On demand mode

2 Internal Rewind (9446)

B5. supply_posn -10to 6 in 1/192 inch (9494/9490)

-99to 99 in 1/192 inch (9446/1460). 0 is the default. Adjusts the machine to print at the vertical 0,0 point on the supply. This adjustment accounts for mechanical tolerances from machine to machine. The supply position adjustment only needs to be made on the initial machine setup. Increase the supply position to move print up, decrease to move print down on the label. Print a test label to verify the 0,0 point. Changing the supply position affects the print position. Once the supply position is set, use the print control packet to adjust printing.

B6. cut_posn -99to 99 in 1/192 inch. Use 0 (no knife on these printers).

See "Defaults" for the default values on each printer.

Example {I,B,0,0,1,10 p }

Indicates black mark and thermal direct stock has been loaded, causes the printer to operate in on-demand mode, and feeds the supply approximately .05 inches up before printing the format on each label (10/192 inches).

3-8

Page 28
Image 28
Paxar TCMPCL2PR manual Defining the Supply Setup Packet, Example I,B,0,0,1,10 p