Chapter 9. Errors

Error Description

Code

757Load Supplies. The calibrated supply length differs by plus or minus .25 inches from the format. Press R to display the format name.

Press e to print on the current supply or load new supply and press E.

758Check Supply. Either the on demand sensor is broken, the supply is not seen, or you have a continuous unit set to on demand mode. Adjust the on demand sensor so it is over a white area on the supply, or set the unit to continuous mode. This message may also appear on printer models that do not have the rewind capability.

759Knife is not moving. Call Technical Support.

760Knife jam. Call Technical Support.

761Stacker is full. Empty the stacker before continuing.

762Low battery. Recharge the battery.

763

Waiting to dispense label. Press the trigger or f.

 

 

If the error persists, call Technical Support.

764Verifier failed. Check the verifier by referring to your verifier’s manual. Call Technical Support.

765The printhead has less than 4 bad dots. The printer can shift bar code fields to avoid bad dots. Press E to continue printing.

768Printhead has more than 10 bad dots or is not connected. Make sure the printhead is connected. You may need a new printhead. Call Technical Support.

9-19

Page 141
Image 141
Paxar TCMPCL2PR manual Error Description Code