Paxar TCMPCL2PR manual DD or

MPCLII Packet Reference Manual

Command		Parameter
^ADxxxxxx	Selects the 9490 printer whose ASCII address is xxxxxx.
^CA	Cancels all the batches in the queue.
^CB	Cancels only the current batch being printed.
^DD or	Disables the MPCL data escape character (the tilde) and inhibits
^DCd	MPCL from acting on ANY data escape sequence from the host. Sets
	the MPCL data escape character to the ASCII value given by the d
	parameter. The value can be any ASCII character.
^EA	Aborts an error condition. May need to be sent multiple times. Use
	^RB to reprint batch. CAUTION: Command causes the current batch
	to stop and the condition that caused the error to remain uncorrected.
^ER	Resets the error. This command is the same as pressing the trigger or
	pressing E to acknowledge an error. Normal operation will resume.
^FD	Feeds a label when printer is idle. Simulates the operation of
	pressing trigger or f and dispenses the next label if printer is in the
	on demand mode. NOTE: Printer ignores this command if printing.
^ID or ^ICd	Disables the Immediate Command feature by turning off the Immediate
	Command escape character. Sets the Immediate Command escape
	character to the ASCII value given by the d parameter. The value can
	be any ASCII character.
^MC	Returns the customer ID or RPQ version to the host. (00 to 99)
^MI	Returns the customer ID or RPQ revision level to the host. (00 to 99)
^MM	Returns the model number to the host. 00 = M9446 01 =
	M1446/M1460
	02= M9490	04= M9494
^MP	Returns the prototype number to the host. (00 to 99)
^MR	Returns the revision number to the host. (00 to 99)
^MV	Returns the version number to the host. (00 to 99)
^PR	Resets the printer. This command takes five seconds to complete and
	then the printer is ready to receive data. It has the same effect as
	turning off and then turning on the printer. NOTE: Command should
	be used only when the printer is not printing.
^RB	Repeats the last printed batch, printing the same number of labels as
	specified in the original batch. This command does not work if using
	batch separators. NOTE: Printer ignores this command if printing.
^RS	Resynchronizes supply when supply roll is changed. NOTE: Printer
	ignores this command if printing.
^SD or	Disables the status polling feature by turning off the status polling
^SCd	control character. Sets the status polling control character to the
	ASCII value given by the d parameter. The value of d can be any
	ASCII character.
^TP	Prints a test label set. NOTE: Printer ignores this command if printing.

The table represents the defined immediate command control character as ^ and the defined status polling control character as d. You may define these characters to suit your needs.

3-24