Chapter 3. Configuring the Printer

Resetting Control Characters

You can change the characters in the previous example back to their original settings by downloading this packet:

{I?E?"~123~044~034~124~125~126~094" p }

Notice that the parameter separator is ? in this packet. This is the parameter separator that was set before this packet. Once the packet is received by the printer, the new parameter separator (a comma, in this case) is valid. Be careful when using this feature. If you forget what the control characters were changed to, print a test label. (The test label lists the current control characters.) See "Printing a Test Label," in Chapter 8 for more information.

Defining the Communication Settings Packet –––––––––––––––––––

Use the communication settings packet (F) to set the baud rate, word length, stop bits, parity, and flow control for serial communications. Changing the communication settings takes approximately two seconds. Communications sent during this interval will be lost.

Syntax {I,F,baud,word_length,stop_bits,parity, flow_control,pr_address p }

F1. F

Communication Settings Packet

F2. baud

Baud Rate. Options:

 

0

1200

 

 

1

2400

(default for 1460)

 

2

4800

 

 

3

9600

(default for 9494/9490/9446)

 

4

19.2K

F3. word_length Word Length. Options:

07-bit word length

18-bit word length (default for all printers)

F4. stop_bits Stop Bits. Options:

01-stop bit (default for all printers)

1 2-stop bits

3-13

Page 33
Image 33
Paxar TCMPCL2PR manual Defining the Communication Settings Packet, Resetting Control Characters