PB Heat Gas/Oil Boilers Venting, Install The Burner, A.Burner Application, C.Mount The Burner

VENTING

5. VENTING

Refer to Chapter 1, Preinstallation, Section D. Chimney or Vent for installation requirements. Refer to Chapter 9, Starting the Boiler, Section C. Run Burner Check Out for damper settings and draft requirements.

6. INSTALL THE BURNER

A.BURNER APPLICATION

1.Refer to Burner Spec and Data Sheets for the Oil and Gas/Oil Burners pre-tested with Series LC boilers.

2.Make sure the nozzle sizing and spray pattern match those given in the spec and data sheets.

3.See Figure 6.1 and Table 6.1 for combustion chamber dimensions.

B.INSTALL BURNER MOUNTING PLATE

1.The Burner Mounting Plate is made to fit the burner being used. Burners vary in bolt pattern for the flange, burner tube diameter, insertion length and near-tube configuration. Make sure the front plate is correct for your burner if purchased separately from the boiler.

2.Remove the Burner Mounting Plate and Hardware Bag from the crate.

3.Screw (7) 3/8"-16 x 2 1/4" studs into the holes in the front section around the chamber opening.

4.Secure the Burner Mounting Plate to the front section with the flat washers and hex nuts.

C.MOUNT THE BURNER

1.Remove the Burner from its crate. Read the burner instructions.

2.Insert (4) 3/8"-16 x 1 1/4" studs supplied with Burner Mounting Plate into the front plate holes.

3.Place the high temperature gasket on the burner front plate and secure the burner to the front plate with 3/8" flat washers and hex nuts.

4.If the burner is supplied with a pedestal, install it to the burner per the Burner Manufacturer’s Instructions. The pedestal provides additional support and prevents the burner from sagging.

29