INSTALLING REAR PANEL BNC CARDS

The following rear panel cards can be used with the CM9770-MXB matrix bay:

CM9770-RPC—the BNC card for video connections

CM9770-RPM—the BNC card for monitor connections

CM9770-DFC—this is a downframe card and cable assembly used to connect multiple matrix bays; refer to the Downframing section in the Appendix for more information

CM9770-DFL—this downframe card and cable assembly is the same as the CM9770-DFC, except that it also has BNC connectors for looping inputs; refer to the Downframing section in the Appendix for more information

Insert or Replace a Rear Panel Video BNC Card (CM9770-RPC)

1.Slide the video BNC card into the card guides at the rear of the bay. From the rear of the bay, the slot at the far right provides the connection point for the video input card inserted in the front of the bay into slot 1. Refer to Figure 6.

NOTE: You will note that the video BNC card consists of two cards connected into one unit. Each video BNC card (CM9770-RPC) provides 32 video input connections and connects to one video input card (CM9770-VCC).

2.Push the BNC card into place firmly.

3.Tighten the screws at the top and bottom of the BNC card.

Remove a Rear Panel Video BNC Card (CM9770-RPC)

1.Loosen the screws at the top and bottom of the BNC card. Refer to Figure 7.

2.Pull the BNC card towards you until it is out of the frame.

TWO RPC CARDS ARE

CONNECTED INTO ONE

UNIT - LOOSEN SCREWS

AT TOP AND BOTTOM TO

REMOVE RPC UNIT

Figure 6. Insert a Rear Panel Video BNC Card (CM9770-RPC)

Figure 7. Remove a Rear Panel Video BNC Card (CM9770-RPC)

C1555M-G (12/07)

17

Page 17
Image 17
Pelco manual Installing Rear Panel BNC Cards, Insert or Replace a Rear Panel Video BNC Card CM9770-RPC