PERFORMING A BASIC LED CHECK

You should perform a basic LED check before you connect any video input or output to the matrix bay. The LED check allows you to ensure that the system is operating properly.

1.Turn on the power switch on the rear of the matrix bay. The front cover can either be open or closed during the LED check.

2.Various LEDs will blink during the initialization process as the software verifies communication and version level information. Once the initialization process is complete, continue to step 3.

NOTE: The initialization process should take approximately 30 seconds, unless the primary CM9770-VMC monitor card is updating software on the other monitor card or on the CM9770-VCC video cards. The software update process takes several minutes.

3.Ensure that the appropriate LEDs are illuminated, as described in Table A.

4.Ensure that the red CF LED on each video input card is off. If this LED is illuminated on any input card, reseat the card. If the problem continues, replace with a known good video input card. If this LED is illuminated on all of the video input cards, there may be a problem with the primary monitor output card (in slot 10). Reseat the primary monitor card. If the problem continues, replace with a known good monitor card.

5.Ensure that the red VF and PF LEDs on the power supply are off.

6.If the LEDs are properly illuminated, turn off the power switch on the rear of the matrix bay, and then install all video inputs and outputs.

 

 

Table A. LEDs Illuminated During a Basic Check

 

 

 

Front Panel Label

Color

Diagnostic Check

 

 

 

Power Supply

 

 

 

 

 

+

Green

On.

 

 

 

-

Green

On.

 

 

 

Monitor Output Card (CM9770-VMC)

 

 

 

+

Green

On.

 

 

 

-

Green

On.

 

 

 

HB

Amber

Blinks at a one-second rate.

 

 

 

RX

Amber

Blinks during normal system operation as switching commands are sent and polled.

 

 

 

MP

Amber

Blinks during normal system operation.

 

 

 

NOTE: The amber FP, CP, and BP LEDs will blink on start-up, but should not remain illuminated.

 

Video Input Card (CM9770-VCC)

 

 

 

+

Green

On.

 

 

 

-

Green

On.

 

 

 

HB

Amber

Blinks at a one-second rate.

 

 

 

VL

Red

This is the video loss LED, and it should be illuminated because there are no video signals coming into the

rear panel yet. During normal operation this LED should be off.

 

 

 

 

 

NOTE: The amber CD LED may blink on start-up, but should not remain illuminated.

 

 

 

Refer to Table H and Table I in the Appendix for additional information on the LEDs and troubleshooting information.

16

C1555M-G (12/07)

Page 16
Image 16
Pelco 9770 manual Performing a Basic LED Check, Table A. LEDs Illuminated During a Basic Check, Color Diagnostic Check