Perle Systems 5500161-40 manual Models, Left VDC + Right

Powering Up the IOLAN

Medical Unit Models

To power up the medical unit IOLAN, perform the following steps:

1.You can attach the multi-function wall plate included with your medical unit IOLAN to the wall, then mount the IOLAN on the wall plate. Alternatively, you can mount the IOLAN on a tabletop or any suitable horizontal surface. See the IOLAN MDC Hardware Installation Guide for more information on how to mount the medical unit IOLAN.

2.Plug a power cable into the left side (power/Ethernet panel) of the IOLAN unit and then into the electrical outlet.

3.Power on the IOLAN unit using the Power ON/OFF switch.

4.You will see the LEDs blink for several seconds and then remain a solid green, indicating that it is ready to configure/use.

I/O Models

To power up the IOLAN, perform the following steps:

1.Unplug the power plugable terminal block from the IOLAN.

2.Loosen the screws and then insert your positive (+) wire into the left terminal and screw it down. Insert the negative (-) wire into the right terminal and screw it down as shown below:

Left

9-30 VDC + -

Right

3.Plug the power terminal block back into the IOLAN.

4.Plug the power supply into the electrical outlet.

5.You will see the LEDs blink for several seconds and then remain a solid green, indicating that it is ready to configure/use.

Before you start to configure the IOLAN, you should set the IOLAN jumpers for Digital I/O (see Digital I/O Module on page 382) or Analog Input (Analog Input Module on page 383) channels.

Hardware and Connectivity 43