Perle Systems 5500161-40 manual Port Desktop Iolan

Introduction

4-Port Desktop IOLAN

To change the settings, do the following:

1.Unplug the IOLAN from the electrical outlet and disconnect everything from the box.

2.Open the case by unscrewing the two side screws, one on each side, and lifting off the top of the case. You should see the following:

Screw

	1	J8
			J4
		J7
2		J11	J5
		J9
3		J24 J22	J10
4		J25 J23	J6

Power

DIP

Switch

Reset

The pin with the square represents Pin 1 --->

RJ45

Screw

3.The following table describes how to jumper the pins for line termination, fixed 5V output, and for output equal to the external adapter input:

Port/Line #	Line Termination	5V Output	Input Volt Output
1	Jumper J7 and J8	J4, jumper pins 1 & 2	J4, jumper pins 2 & 3
2	Jumper J9 and J11	J5, jumper pins 1 & 2	J5, jumper pins 2 & 3
3	Jumper J22 and J24	J10, jumper pins 1 & 2	J10, jumper pins 2 & 3
4	Jumper J23 and J25	J6, jumper pins 1 & 2	J6, jumper pins 2 & 3

4.Close the IOLAN case by replacing the case lid and the two screws. You can now power it on with the new settings.

Setting Jumpers 381