Perle Systems 5500161-40 manual Port Iolan RJ45 P Power Over Ethernet

Introduction

1-Port IOLAN RJ45

To change the settings, do the following:

1.Unplug the IOLAN from the electrical outlet and disconnect everything from the box.

2.Open the case by unscrewing the two side screws, one on each side, and lifting off the top of the case. You should see the following:

J4

Pin1

J9

RJ45 Serial 1J

Screw

DIP	Power
Switch	Reset
	RJ45

Screw

3.To change the power pin out, locate J4. For the fixed 5V DC output, jumper pins 1 and 2. For the output to equal the external adapter input, jumper pins 2 and 3.

4.To turn line termination on, locate and jumper both J1 and J9.

5.Close the IOLAN case by replacing the case lid and the two screws. You can now power it on with the new settings.

1-Port IOLAN RJ45 P (Power Over Ethernet)

To change the settings, do the following:

1.Unplug the IOLAN from the electrical outlet and disconnect everything from the box.

2.Open the case by unscrewing the two side screws, one on each side, and lifting off the top of the case. You should see the following:

	Screw
	J4 Pin1
RJ45
Serial	J8 J7
	Screw

DIP	Power
Switch	Reset
	RJ45

3.To change the power pin out, locate J4. For the fixed 5V DC output, jumper pins 1 and 2. For the output to equal the external adapter input, jumper pins 2 and 3.

4.To turn line termination on, locate and jumper both J7 and J8.

5.Close the IOLAN case by replacing the case lid and the two screws. You can now power it on with the new settings.

378 IOLAN SDS/SCS/STS/MDC User’s Guide, Version 4.0