Perle Systems 5500161-40 manual DHCP/BOOTP Parameters, TACACS+ Securid

DHCP/BOOTP

DHCP/BOOTP Parameters

The following parameters can be set in the DHCP/BOOTP bootp file:

zSW_FILE—The full path, pre-fixed by hostname/IP address (IPv4 or IPv6), and file name of the firmware update.

zCONFIG_FILE—The full path, pre-fixed by hostname/IP address (IPv4 or IPv6), and file name of the configuration file.

zGUI_ACCESS—Access to the IOLAN from the HTTP or HTTPS WebManager. Values are on or off.

zAUTH_TYPE—The authentication method(s) employed by the IOLAN for all users. You can specify the primary and secondary authentication servers, separated by a comma. This uses the following numeric values for the authentication methods.

–0—None (only valid for secondary authentication)

–1—Local

–2—RADIUS

–3—Kerberos

–4—LDAP

–5—TACACS+

–6—SECURID

–7—NIS

zSECURITY—Restricts IOLAN access to devices listed in the IOLAN’s host table. Values are yes or no.

zTFTP_RETRY—The number of TFTP retries before aborting. This is a numeric value, for example, 5.

zTFTP_TMOUT—The time, in seconds, before retrying a TFTP download/upload. This is a numeric value, for example, 3.

zCUSTOM_LANG—The full path, pre-fixed by a hostname/IP address (IPv4 or IPv6), and file name of a translated language file. For example,

192.101.34.211 /accounting/Iolan_ds_german.txt.

zEXTRA_TERM1—(EXTRA_TERM2, EXTRA_TERM3) The full path, pre-fixed by a hostname/IP address (IPv4 or IPv6), and file name of a termcap file for a specific terminal type.

64 IOLAN SDS/SCS/STS/MDC User’s Guide, Version 4.0