Philips HDRW 720/00-02 operating instructions Press GUIDE/TV

Before you call an engineer

PROBLEMSOLUTION

The wrong TV channel was decoded (recorded) after you programmed a recording using ShowView System.

bThe programme number of the TV channel is not available in the GUIDE Plus+® system or allocation is wrong.

To change or check the channel data, proceed as follows:

1Press GUIDE/TV .

2Press A .

3Select 'Editor' with C .

4Select the TV channel using B or A .

5Press C to go to the right tile.

In case you can receive the selected channel only via an external receiver, press the red button to select the corresponding source.

6Press the green button.

7Enter the programme number of the TV channel using the number buttons.

If the source you have selected is an external receiver, enter the programme number that you would also enter at the external receiver for this TV channel.

8 Confirm with OK .

There is no channel overview in the GUIDE Plus+® system

Missing or wrong TV channel in the 'Grid' screen

When you press GUIDE/TV the GUIDE Plus+® setup screen will appear

The external receiver does not always react to Remote control signal.

My external receiver switches automatically through the TV channels

There is picture or sound interference on TV reception:

Distorted sound coming from a connected hi amplifier

bDVD recorder is switched on: Switch off the DVD recorder to allow data transfer bThe TV channel that transmits the GUIDE Plus+® data is not set properly.

bExternal receiver (satellite receiver, set-top box, cable TV box, ...) (if available) is switched off: switch on the external receiver

bG-LINK cable is not connected: Connect the G-LINK cable and make the necessary settings to control the external receiver (see chapter 'The GUIDE Plus+® system', section 'Installation of the 'External receiver 1'').

bWrong local post code/country was entered

bPlease check your correct channel line up in the 'Grid' screen. Read therefore the section 'The 'Editor' screen.

bThe GUIDE Plus+® system was not completely installed or local post code was not entered.

1Check the settings

2Select the corresponding line using B or A and confirm with OK .

3For more information on the individual functions, see chapter 'The GUIDE Plus+® system', section 'Setting up the GUIDE Plus+® System'.

bThe Infrared (IR) Remote control signal interfere with the IR signal of the G-LINK transmitter. Put the G-LINK transmitter closer to the front of the external receiver.

bIf the DVD-Recorder is switched off ( STANDBY m button) the external receiver will be used from the GUIDE Plus+® system via the DVD-Recorder.

If you want to watch TV-Channels from the external receiver, you have to switch the DVD-Recorder on.

bBefore recording, select the recording mode as described in chapter 'Manual Recording', section 'Selecting the recording mode (quality)'.

bHave your aerial checked.

bYou will find information on how to change the TV system in 'Manual TV channel search' in 'Installing your DVD recorder'.

bThe DVD recorder is connected to the 'Phono-input' of your amplifier: This socket is provided only for a record players without a preamplifier. Select a different audio input.

86