Q-Logic 59021-05 B manual Table B-7. Set Config Port Parameters Continued, Description

Q

B – Command Line Interface Set Config Command

Table B-7. Set Config Port Parameters (Continued)

Parameter	Description
DeviceScanEnabled	Enables (True) or disables (False) the scanning of the
	connected device for FC-4 descriptor information during
	login. The default is True.
ForceOfflineRSCN	Enables (False) or disables (True) the immediate
	transmission of RSCN messages when communication
	between a port and its device is interrupted. If enabled, the
	RSCN message is queued for 200 ms. The default is
	False. This parameter is ignored if IOStreamGuard is
	enabled.
ARB_FF	Use ARB_FF instead of idles on loop FCAL option
InteropCredit	Interoperability credit. The number of buffer-to-buffer
	credits per port. 0 means the default (12) is unchanged.
ExtCredit	Extended credits. The number of port buffer credits that
	this port can acquire from donor ports.
FANEnable	Fabric address notification. Enables (True) or disables
	(False) the communication of the FL_Port address, port
	name, and node name to the logged-in NL_Port.
LCFEnable	Link control frame preference, R_CTL = 0xC
MFS_TOV	MFS limit for camp on
MFSEnable	Multi-Frame Sequence bundling
MSEnable	Management Server enable on this port
NoClose	Don't close unless another device arbitrates
IOStreamGuard	Enables or disables the suppression of RSCN messages
VIEnable	Enable VI preference routing
CheckAlps	Close before sending frames to new target

59021-05 B B-27