Q-Logic 59021-05 B manual perf option, Table B-13. Show Port Parameters, port portnumber

Q

B – Command Line Interface Show Command

perf [option]

Displays performance information for all ports. Refer to the ”Show Perf Command” on page B-58.

port [port_number]

Displays operational information for the port given by [port_number]. Ports are numbered beginning with 0. If the port number is omitted, information is displayed for all ports. Table B-13describes the port parameters.

Table B-13. Show Port Parameters

Entry	Description
AIinit	Incremented each time the port begins AL initialization.
AIinitError	Number of times the port entered initialization and the
	initialization failed.
ClassXFramesIn	Number of class x frames received by this port.
ClassXFramesOut	Number of class x frames sent by this port.
ClassXWordsIn	Number of class x words received by this port.
ClassXWordsOut	Number of class x words sent by this port.
DecodeError	Decoding error detected.
FBusy	Number of times the switch sent a F_BSY because Class 2
	frame could not be delivered within ED_TOV time. Number
	of class 2 and class 3 fabric busy (F_BSY) frames
	generated by this port in response to incoming frames.
	This usually indicates a busy condition on the fabric or
	N_Port that is preventing delivery of this frame.
Flowerrors	Received a frame when there were no available credits.
FReject	Number of frames from devices that were rejected.
InvalidCRC	Invalid CRC detected.
InvalidDestAddr	Invalid destination address detected.
LIP_AL_PD_AL_PS	Number of F7, AL_PS LIPs, or AL_PD (vendor specific)
	resets, performed.
LIP_F7_AL_PS	This LIP is used to reinitialize the loop. An L_port, identified
	by AL_PS, may have noticed a performance degradation
	and is trying to restore the loop.
LIP_F8_AL_PS	This LIP denotes a loop failure detected by the L_port
	identified by AL_PS.

59021-05 B B-45