Q-Logic 59021-05 B manual Set Setup Command, Set setup, Snmp System

B – Command Line Interface Set Setup Command

Q

Set Setup Command

Changes SNMP and system configuration settings. The switch maintains one SNMP configuration and one system configuration.

Authority	Admin
Syntax	set setup
	snmp
	system
Keywords	snmp
	Prompts you in a line-by-line fashion to change SNMP configuration settings.
	Table B-11describes the SNMP fields. For each parameter, enter a new value or
	press the Enter key to accept the current value shown in brackets.
	Table B-11. SNMP Configuration Settings
	Entry	Description
	Contact	Specifies the name of the person to be contacted to respond
		to trap events. The default is undefined.
	Location	Specifies the name of the switch location. The default is
		undefined.
	Trap [1-5] Address	Specifies the workstation IP address to which SNMP traps
		are sent. The default address for trap 1 is 10.0.0.254. The
		default address for traps 2–5 is 0.0.0.0.
	Trap [1-5] Port	Specifies the workstation port to which SNMP traps are sent.
	Trap [1-5] Severity	Specifies the severity level to use when monitoring trap
		events. The default is Warning
	Trap [1-5] Version	Specifies the SNMP version (1 or 2) to use in formatting
		traps. The default is version 2.
	Trap [1-5] Enabled	Specifies whether traps (event information) are enabled or
		disabled (default).
	ReadCommunity	Read community password that authorizes an SNMP agent
		to read information from the switch. This is a write-only field.
		The value on the switch and the SNMP management server
		must be the same. The default is “public”.
	WriteCommunity	Write community password that authorizes an SNMP agent
		to write information to the switch. This is a write-only field.
		The value on the switch and the SNMP management server
		must be the same. The default is “private”.

B-38 59021-05 B