Q-Logic 59021-05 B manual Set Config Command, Set config, Port portnumber, Ports portnumber

B – Command Line Interface Set Config Command

Q

Set Config Command

Sets switch, port, alarm threshold, and zoning configuration parameters.

Authority	Admin authority and a Config Edit session
Syntax	set config
	port [port_number]
	ports [port_number]
	switch
	threshold
	zoning
Keywords	port [port_number]
	Initiates an edit session in which to change configuration parameters for the port
	number given by [port_number]. If you omit [port_number], the system begins with
	port 0 and proceeds in order through the last port. For each parameter, enter a
	new value or press the Enter key to accept the current value shown in brackets.
	Enter “q” to cancel the configuration for one port, or “qq” to cancel the
	configuration for all ports. Table B-7describes the port parameters.
	ports [port_number]
	Initiates an editing session in which to change configuration parameters for all
	ports based on the configuration for the port given by [port_number]. If you omit
	[port_number], port 0 is used. For each parameter, enter a new value or press the
	Enter key to accept the current value shown in brackets. Enter “q” to cancel the
	configuration. Table B-7describes the port parameters.
	Table B-7. Set Config Port Parameters
	Parameter	Description
	AdminState	Port administrative state: online, offline, diagnostics, or
		down.
	LinkSpeed	1Gb/sec, 2 Gb/sec, or Auto
	PortType	Type of port
	ISLSecurity	E_Port security. Determines which switches a port will
		establish a link with.
		„ Any - link with any FC-SW-2 compliant switch.
		„ Ours - link only with an FC-SW-2 compliant QLogic
		switch.
		„ None - reject the link.
	SymbolicPortName	Descriptive name
	ALFairness	Arbitration loop fairness. Enables (True) or disables
		(False) the switch’s priority to arbitrate on the loop.

B-26 59021-05 B