
Q
SANbox2-16 Fibre Channel Switch Installation Guide
4.2.3 | Connect the Switch to AC Power | |
4.2.4 | Connect the Management Workstation to the Switch | |
4.2.4.1 | Ethernet Connection | |
4.2.4.2 | Serial Connection | |
4.2.5 | Install SANbox Manager | |
4.2.6 | SANsurfer Management Suite Disk - Windows Installation | |
4.2.7 | SANsurfer Management Suite Disk - Linux Installation | |
4.2.8 | SANsurfer Management Suite Disk - Solaris Installation | |
4.2.9 | SANbox2 Installation Disk - Windows Installation | |
4.2.10 | SANbox2 Installation Disk - Linux Installation | |
4.2.11 | SANbox2 Installation Disk - Solaris Installation | |
4.2.12 | Configure the Switch | |
4.2.13 | Configure the Ports | |
4.2.14 | Cable Devices to the Switch | |
4.3 | Install Firmware | |
4.3.1 | Using SANbox Manager to Install Firmware | |
4.3.2 | Using the CLI to Install Firmware | |
4.3.3 | Using FTP and the CLI to Install Firmware | |
4.4 | Powering Down a Switch |
Section 5 | Diagnostics/Troubleshooting |
|
5.1 | POST Diagnostics | |
5.1.1 | Heartbeat LED Blink Patterns | |
5.1.1.1 | Normal (all pass) | |
5.1.1.2 | Maintenance Mode Pattern | |
5.1.1.3 | Internal Firmware Failure Blink Pattern | |
5.1.1.4 | Fatal Error Blink Pattern | |
5.1.1.5 | Configuration File System Error Blink Pattern | |
5.1.2 | ||
5.1.2.1 | E_Port Isolation | |
5.1.2.2 | Excessive Port Errors | |
5.2 | Chassis Diagnostics | |
5.2.1 | Chassis Over Temperature LED is Illuminated | |
5.2.2 | Input Power LED Is Extinguished | |
5.2.3 | Fan Fail LED is Illuminated | |
5.2.4 | Output Power LED Is Extinguished | |
5.2.5 | Power Supply Over Temperature LED is Illuminated | |
5.3 | Recovering a Switch | |
5.3.1 | Maintenance – Exit | |
5.3.2 | Maintenance – Image Unpack |
Page v |