
B – Command Line Interface Set Config Command
Q
zoning
Initiates an editing session in which to change switch zoning attributes. The system displays each parameter one line at a time and prompts you for a value. For each parameter, enter a new value or press the Enter key to accept the current value shown in brackets.
Table B-10. Set Config Zoning Parameters
Parameter | Description |
|
|
AutoSave | Enables (True) or disables (False) the |
| saving of changes to active zone set in |
| the switch’s permanent memory. |
| Changes are always saved in the |
| switch’s temporary memory. |
Default | Enables (All) or disables (None) |
| communication among the switch’s |
| ports/devices and the fabric in the |
| absence of an active zone set. |
|
|
Examples The following is an example of the Set Config Port command:
SANbox2 #> admin start
SANbox2 (admin) #> config edit
SANbox2
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate | this process before reaching the end of the list | |||
press 'q' or 'Q' and the | ENTER key to do so. |
|
| |
Configuring Port Number: | 1 |
|
| |
|
|
| ||
AdminState | (1=Online, | 2=Offline, 3=Diagnostics, 4=Down) | [Online] | |
LinkSpeed | (1=1Gb/s, 2=2Gb/s, 3=Auto) | [Auto | ] | |
PortType | (TL / GL / | G / F / FL / Donor) | [GL | ] |
ISLSecurity | (Any / Ours / None) | [Any | ] | |
SymPortName | (string, max=32 chars) | [Port1 ] | ||
ALFairness | (True / False) | [False ] | ||
DeviceScanEnable (True / | False) | [True | ] | |
ForceOfflineRSCN (True / | False) | [False | ] | |
ARB_FF | (True / False) | [False | ] | |
InteropCredit | (decimal value, | [0 | ] | |
ExtCredit | (dec value, increments of 11, | [0 | ] |