Q-Logic 59048-02 A manual Table A-14. System Configuration Settings

Q

A – Command Line Interface Set Setup Command

Table A-13. SNMP Configuration Settings (Continued)

Entry	Description
TrapCommunity	Trap community password that authorizes an SNMP agent to
	receive traps. This is a write-only field. The value on the switch
	and the SNMP management server must be the same. The
	default is “public”.
AuthFailureTrap	Enables (True) or disables (False) the generation of traps in
	response to trap authentication failures. The default is False.
ProxyEnabled	Enables (True) or disables (False) SNMP communication with
	other switches in the fabric. The default is True.

system

Prompts you in a line-by-line fashion to change system configuration settings. Table A-14describes the system configuration fields. For each parameter, enter a new value or press the Enter key to accept the current value shown in brackets.

Note: Changing the IP address will terminate all Ethernet management sessions.

Table A-14. System Configuration Settings

Entry	Description
Eth0NetworkDiscovery	Ethernet boot method: 1 - Static, 2 - Bootp, 3 - DHCP,
	4 - RARP. The default is 1 - Static.
Eth0NetworkAddress	Ethernet Internet Protocol (IP) address. The default is
	10.0.0.1.
Eth0NetworkMask	Ethernet subnet mask address.
Eth0GatewayAddress	Ethernet IP address gateway.
FCNetworkDiscovery	Fibre Channel boot method: 1 - Static, 3 - DHCP. The
	default is 1 - Static.
FCNetworkAddress	Fibre Channel Internet Protocol (IP) address for the
	Ethernet port. The default is 0.0.0.0.
FCNetworkMask	Fibre Channel subnet mask address. The default is
	255.0.0.0.
FCGatewayAddress	Fibre Channel IP address gateway. The default is
	10.0.0.254.

59048-02 A A-47