Q-Logic 59048-02 A manual Table A-12. Set Config Zoning Parameters

Q

A – Command Line Interface Set Config Command

Table A-11. Set Config Threshold Parameters (Continued)

Parameter	Description
Rising Trigger	The event count above which a rising threshold
	alarm is logged. The switch will not generate
	another rising threshold alarm for that event until
	the count descends below the falling threshold
	and again exceeds the rising threshold.
Falling Trigger	The event count below which a falling threshold
	alarm is logged. The switch will not generate
	another falling threshold alarm for that event until
	the count exceeds the rising threshold and
	descends again below the falling threshold.
Sample Window	The period of time in seconds in which to count
	events.

zoning

Initiates an editing session in which to change switch zoning attributes. The system displays each parameter one line at a time and prompts you for a value. For each parameter, enter a new value or press the Enter key to accept the current value shown in brackets.

Table A-12. Set Config Zoning Parameters

Parameter	Description
FC-SW-2 AutoSave	Available only when the FC-SW-2
	Compliant parameter is True, this
	parameter enables (True) or disables
	(False) the saving of changes to active
	zone set in the switch’s permanent
	memory. Refer to ”FC-SW-2 Compliant” on
	page A-36. The default is True.
Default	Enables (All) or disables (None)
	communication among the switch’s ports/
	devices and the fabric in the absence of an
	active zone set. The default is All.

59048-02 A A-37