Q-Logic 59048-02 A manual Table A-11. Set Config Threshold Parameters

A – Command Line Interface Set Config Command

Q

Table A-10. Set Config Switch Parameters (Continued)

Parameter	Description
FC-SW-2 Compliant	Propagates just the active zone set
	throughout the fabric (True, compliant) or
	the entire zoning database (False, non-
	compliant). The default is True.
LegacyAddressFormat	Available only when the FC-SW-2
	Compliant parameter is False, this
	parameter enables (True) or disables
	(False) the use of legacy address
	formatting for interoperating with non-FC-
	SW-2 switches. Refer to ”FC-SW-2
	Compliant” on page A-36. The default is
	False.

threshold

Initiates a configuration session by which to generate and log alarms for selected events. The system displays each event, its thresholds, and sampling interval one line at a time and prompts you for a value. For each parameter, enter a new value or press the Enter key to accept the current value shown in brackets. These parameters must be saved in a configuration and activated before they will take effect. Refer to the ”Config Command” on page A-7for information about saving and activating a configuration. Table A-11describes the Set Config Threshold parameters. The switch will down a port if an alarm condition is not cleared within three consecutive sampling intervals (by default 30 seconds). Reset the port to bring it back online. An alarm is cleared when the threshold monitoring detects that the error rate has fallen below the falling threshold.

Table A-11. Set Config Threshold Parameters

Parameter		Description
Threshold Monitoring Enabled	Master enable/disable parameter for all events.
	Enables (True) or disables (False) the generation
	of all enabled event alarms. The default is False.
CRCErrorsMonitoringEnabled	The event type enable/disable parameter.
DecodeErrorsMonitoringEnabled	Enables (True) or disables (False) the generation
ISLMonitoringEnabled	of alarms for each of the following events:
LoginMonitoringEnabled	„	CRC errors
LogoutMonitoringEnabled	„	Decode errors
LOSMonitoringEnabled	„	ISL connection count
	„	Device login errors
	„	Device logout errors
	„ Loss-of-signal errors

A-36 59048-02 A