Q-Logic 59048-02 A manual Following is an example of the Set Config Zoning command

Q

A – Command Line Interface Set Config Command

SampleWindow	(decimal value, 1-1000 sec) [10 ]
ISLMonitoringEnabled	(True / False)	[True]
RisingTrigger	(decimal value, 1-1000)	[2 ]
FallingTrigger	(decimal value, 0-1000)	[0 ]
SampleWindow	(decimal value, 1-1000 sec) [10 ]
LoginMonitoringEnabled	(True / False)	[True]
RisingTrigger	(decimal value, 1-1000)	[5 ]
FallingTrigger	(decimal value, 0-1000)	[1 ]
SampleWindow	(decimal value, 1-1000 sec) [10 ]
LogoutMonitoringEnabled	(True / False)	[True]
RisingTrigger	(decimal value, 1-1000)	[5 ]
FallingTrigger	(decimal value, 0-1000)	[1 ]
SampleWindow	(decimal value, 1-1000 sec) [10 ]
LOSMonitoringEnabled	(True / False)	[True]
RisingTrigger	(decimal value, 1-1000)	[100 ]
FallingTrigger	(decimal value, 0-1000)	[5 ]
SampleWindow	(decimal value, 1-1000 sec)	[10	]

Finished configuring attributes.

This configuration must be saved (see config save command) and activated (see config activate command) before it can take effect. To discard this configuration use the config cancel command.

The following is an example of the Set Config Zoning command.

SANbox2 #> admin start

SANbox2 (admin) #> config edit

SANbox2 (admin-config) #> set config zoning

A list of attributes with formatting and current values will follow.

Enter a new value or simply press the ENTER key to accept the current value.

If you wish to terminate this process before reaching the end of the list press 'q' or 'Q' and the ENTER key to do so.

FC-SW-2	AutoSave	(True / False)	[True]
Default		(All / None)	[All ]

Finished configuring attributes.

This configuration must be saved (see config save command) and activated (see config activate command) before it can take effect. To discard this configuration use the config cancel command.

59048-02 A A-41