Q-Logic 59048-02 A manual This process before reaching the end of the list

A – Command Line Interface Set Setup Command

Q

Table A-14. System Configuration Settings (Continued)

Entry	Description
AdminTimeout	Specifies the amount of time in minutes the switch
	waits before terminating an idle Admin session. Zero
	(0) disables the time out threshold. The default is 30,
	the maximum is 1440.
SecurityEnabled	Enables (True) or disables (False) the enforcement of
	account names and passwords. The default is False.
LocalLogEnabled	Enables (True) or disables (False) the saving of log
	information on the switch. The default is True.
RemoteLogEnabled	Enables (True) or disables (False) the recording of
	the switch event log on a remote host that supports
	the syslog protocol. The default is False.
RemoteLogHostAddress	The IP address of the host that will receive the switch
	event log information if remote logging is enabled.
	The default is 10.0.0.254.

Examples The following is an example of the Set Setup SNMP command:

SANbox2 #> admin start

SANbox2 (admin) #> set setup snmp

A list of attributes with formatting and current values will follow.

Enter a new value or simply press the ENTER key to accept the current value.

If you wish to terminate		this process before reaching the end of the list
press 'q' or 'Q' and the		ENTER key to do so.
Trap Severity Options
---------------------
unknown, emergency,	alert, critical, error, warning, notify, info, debug, mark
Contact	(string, max=32		chars)	[<sysContact undefined]
Location	(string, max=32		chars)	[sysLocation undefined]
Trap1Address	(dot-notated IP		Address)	[10.20.71.15	]
Trap1Port	(decimal value)			[162	]
Trap1Severity	(see	allowed options above)		[warning	]
Trap1Version	(1 /	2)		[2	]
Trap1Enabled	(True / False)			[False	]
Trap2Address	(dot-notated IP		Address)	[0.0.0.0	]
Trap2Port	(decimal value)			[162	]
Trap2Severity	(see	allowed options above)		[warning	]
Trap2Version	(1 /	2)		[2	]

A-48 59048-02 A