Q-Logic 59048-02 A manual LIP Alpd Alps

Q

A – Command Line Interface Show Command

Table A-15. Show Port Parameters (Continued)

Entry	Description
Flowerrors	Received a frame when there were no available credits.
FReject	Number of frames from devices that were rejected.
InvalidCRC	Invalid CRC detected.
InvalidDestAddr	Invalid destination address detected.
LIP ALPD ALPS	Number of F7, AL_PS LIPs, or AL_PD (vendor specific)
	resets, performed.
LIPF7ALPS	This LIP is used to reinitialize the loop. An L_Port, identified
	by AL_PS, may have noticed a performance degradation and
	is trying to restore the loop.
LIPF8ALPS	This LIP denotes a loop failure detected by the L_Port
	identified by AL_PS.
LIPF7F7	A loop initialization primitive frame used to acquire a valid
	AL_PA.
LIPF8F7	A loop initialization primitive frame used to indicate that a loop
	failure has been detected at the receiver.
Link Failures	Number of optical link failures detected by this port. A link
	failure is a loss of synchronization or by loss of signal while
	not in the offline state. A loss of signal causes the switch to
	attempt to re-establish the link. If the link is not re-established,
	a link failure is counted. A link reset is performed after a link
	failure.
Login	Number of device logins
Logout	Number of device logouts
LoopTimeouts	A two (2) second timeout as specified by FC-AL-2.
LossOfSync	Number of synchronization losses (>100 ms) detected by this
	port. A loss of synchronization is detected by receipt of an
	invalid transmission word.
PrimSeqErrors	Primitive sequence errors detected.
RxLinkResets	Number of link reset primitives received from an attached
	device.
RxOfflineSeq	Number of offline sequences received. An OLS is issued for
	link initialization, a Receive & Recognize Not_Operational
	(NOS) state, or to enter the offline state.
TotalErrors	Total number of errors detected.

59048-02 A A-53