Q-Logic 59048-02 A manual Table A-10. Set Config Switch Parameters

Q

A – Command Line Interface Set Config Command

switch

Initiates an editing session in which to change switch configuration settings. The system displays each parameter one line at a time and prompts you for a value. For each parameter, enter a new value or press the Enter key to accept the current value shown in brackets.

Table A-10. Set Config Switch Parameters

Parameter	Description
AdminState	Switch administrative state: online, offline,
	or diagnostics. The default is Online.
BroadcastEnabled	Broadcast. Enables (True) or disables
	(False) forwarding of broadcast frames.
	The default is True.
InbandEnabled	Inband management. Enables (True) or
	disables (False) the ability to manage the
	switch over an ISL. The default is True.
DefaultDomainID	Default domain ID. The default is 1.
DomainIDLock	Prevents (True) or allows (False) dynamic
	reassignment of the domain ID. The
	default is False.
SymbolicName	Descriptive name. The default is
	SANbox2.
R_A_TOV	Resource Allocation Timeout Value. The
	number of milliseconds the switch waits to
	allow two ports to allocate enough
	resources to establish a link. The default is
	10000.
E_D_TOV	Error Detect Timeout Value. The number
	of milliseconds a port is to wait for errors to
	clear. The default is 2000.
PrincipalPriority	The priority used in the FC-SW-2 principal
	switch selection algorithm. 1 is high, 255 is
	low. The default is 254.
ConfigDescription	The name for the configuration. The
	default is undefined.

59048-02 A A-35