Q-Logic 59048-02 A manual Reset Command, Authority Admin Syntax reset, Config configname

Q

A – Command Line Interface Reset Command

Reset Command

Resets the switch configuration parameters. If you omit the keyword, the default is Reset Switch.

Authority Admin

Syntax reset

blade [slot_number] config [config_name] factory

port [port_number] snmp

switch (default) system zoning

Keywords blade [slot_number]

Resets the I/O or cross-connect blade that occupies the slot given by [slot_number]. I/O blade slot numbers are 1–4 and 6–9; cross-connect slot numbers are 11–12.

config [config_name]

Resets the configuration given by [config_name] to the factory default values for switch, port, alarm threshold, and zoning configuration. If [config_name] does not exist on the switch, a configuration with that name will be created. If you omit [config_name], the active configuration is reset. You must activate the configuration for the changes to take effect. Refer to Table A-3through Table A-6for switch, port, and alarm threshold configuration default values.

factory

Resets switch configuration, port configuration, alarm threshold configuration, zoning configuration, SNMP configuration, system configuration, and zoning to the factory default values. The switch configuration is activated automatically. Refer to Table A-3through Table A-8.

port [port_number]

Reinitializes the port given by [port_number]. Ports are numbered beginning with 0.

snmp

Resets the SNMP configuration settings to the factory default values. Refer to Table A-7for SNMP configuration default values.

switch

Resets the switch without a power-on self test. This reset disrupts traffic and activates the pending firmware. This command also closes all management sessions. This is the default. To reset the switch with a power-on self test, refer to the ”Hardreset Command” on page A-13. To reset the switch without disrupting traffic, refer to the ”Hotreset Command” on page A-16.

59048-02 A A-25