Q-Logic SANBOX2-64 manual Serial Port Pin Identification

2 – General Description	￿
Serial Port

2.5

Serial Port

The SANbox2-64 switch is equipped with an RS-232 serial port for maintenance purposes. The serial port is located on the CPU module as shown in Figure 2-8.

6	1
Serial Port
9	5

Figure 2-8. Serial Port

The serial port connector requires a null-modem F/F DB9 cable. The pins on the switch RS-232 connector, shown in Figure 2-8, are identified in Table 2-1. Refer to ”Connect the Management Workstation to the Switch” on page 4-7for information about connecting the management workstation through the serial port.

	Table 2-1. Serial Port Pin Identification
Pin Number	Description
1	Carrier Detect (DCD)
2	Receive Data (RxD)
3	Transmit Data (TxD)
4	Data Terminal Ready (DTR)
5	Signal Ground (GND)
6	Data Set Ready (DSR)
7	Request to Send (RTS)
8	Clear to Send (CTS)
9	Ring Indicator (RI)

2-12 59043-01 A