Q-Logic SANBOX2-64 manual SANbox2-64 Rail Kit

4 – Installation	￿
Installing a Switch

The switch is designed to be mounted in a rack using the mounting brackets and the SANbox2-64 rail kit shown in Figure 4-2. To mount the switch in a rack, do the following. Rack mounting instructions can also be found in the SANbox2-64 Rack Mounting Guide packaged with the switch.

6
4		8
2
9		5
1
		6
9	1	3
		7
	Figure 4-2. SANbox2-64 Rail Kit

1.You can install the switch in a rack “fans first” or “faceplate first”. The switch comes with two brackets (1) fastened to the front of the switch for a fans-first installation. These instructions assume a fans-first installation. To install the switch in the rack faceplate first, remove the mounting brackets and reinstall them on the rear corners of the switch.

2.Install left (2) and right (3) switch rails on the switch using six 8-32 screws (4) for each. Be sure that the latch is closest to the end of the switch that will be installed first in the rack and that the latch tab (5) is pointing down.

3.Extend the rack rails (6) to fit the inner dimensions of the rack. The rail flanges on both ends fit inside the rack. Be sure that the inner rail is toward the front. Fasten the front rail flange to the rack with two 10-32 screws (7) using the upper and lower holes. Fasten the rear end of the rail to the rack with three 10-32 screws (8).

4.Slide the switch and rail assembly into the rack rails. Fasten the switch to the rack with two screws (9), one through each bracket.

4-4 59043-01 A