4 – Installation

￿

Installing a Switch

4.2.4.1

Ethernet Connection

To establish an Ethernet connection, do the following:

1.Connect a 10/100 Base-T cross-over cable from an RJ-45 port on the management workstation directly to the RJ-45 Ethernet port; or a 10/100 Base-T straight cable indirectly over an Ethernet network.

2.Open a command line window.

3.Open a Telnet session by entering the following command with the switch IP address. The default IP address is 10.0.0.1

telnet 10.0.0.1

4.Log in to the switch. If fabric security is disabled, account names and passwords are not enforced. Refer to the ”Set Setup Command” on page B- 40 for information about setting fabric security. The default account name and password are (admin, password).

SANbox2 Login: admin

Password: ********

4.2.4.2

Serial Connection

To establish a serial port connection, do the following:

1.Connect a null modem F/F DB9 cable from a COM port on the management workstation to the RS-232 serial port on the switch.

2.Configure the connection according to your platform:

For Windows:

a.Open the HyperTerminal application on a Windows platform. Choose the Start button, select Programs, Accessories, HyperTerminal, and HyperTerminal.

b.Enter a name for the switch connection and choose an icon in the Connection Description window. Choose the OK button.

c.Select the COM port in the Connect To window and choose the OK button.

d.Enter the following COM Port settings in the COM Properties window and choose the OK button.

Bits per second: 9600

Data Bits: 8

Parity: None

Stop Bits: 1

Flow Control: None

4-8

59043-01 A

Page 54
Image 54
Q-Logic SANBOX2-64 manual Ethernet Connection, Serial Connection