Q-Logic SANBOX2-64 manual Table B-10. Set Config Zoning Parameters

￿	B – Command Line Interface
	Set Config Command

zoning

Initiates an editing session in which to change switch zoning attributes. The system displays each parameter one line at a time and prompts you for a value. For each parameter, enter a new value or press the Enter key to accept the current value shown in brackets.

Table B-10. Set Config Zoning Parameters

Parameter	Description
AutoSave	Enables (On) or disables (Off) the saving
	of changes to active zone set in the
	switch’s permanent memory. Changes are
	always saved in the switch’s temporary
	memory.
Default	Enables (All) or disables (None)
	communication among the switch’s ports/
	devices and the fabric in the absence of an
	active zone set.

Examples The following is an example of the Set Config Blade command:

SANbox2-64 108 (admin-config) #> set config blade 1

A list of attributes		with formatting and current values will follow.
Enter a new value or		simply press the	ENTER key to accept the default value.
If you wish to terminate this process			before reaching the end of the list
press ’q’ or ’qq’ and the ENTER key to do so.
Configuring Blade in		Slot Number: 1
---------------------------------
AdminState	(1=Online, 2=Offline, 3=Diagnostics, 4=Down) [Online]
Finished configuring		attributes.
This configuration must be saved (see			config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the			config cancel command.

59043-01 A B-31