Q-Logic SANBOX2-64 Site Requirements, Fabric Management Workstation, Switch Power Requirements

Section 4

Installation

This section describes how to install and configure the SANbox2-64 switch. It also describes how to load new firmware and how to recover a disabled switch.

4.1

Site Requirements

The following items are required for the installation of a SANbox2-64 switch:

■Fabric management workstation

■Power requirements

■Environmental conditions

4.1.1

Fabric Management Workstation

The requirements for fabric management workstations running SANbox Manager are described in Table 4-1:

Table 4-1. Management Workstation Requirements

Operating System	■	Windows® NT, 2000, 95/98
	■	Linux® 6.2 Red Hat®
	■	Solaris
Memory	128 MB or more
Disk Space	150		MB per installation
Processor	300		MHz or faster
Hardware	CD-ROM drive, RS-232 serial port, RJ-45 Ethernet port
Internet Browser	Microsoft® Internet Explorer® or Netscape Navigator®

Telnet workstations require an RJ-45 Ethernet port or an RS-232 serial port and an operating system with a Telnet client.

4.1.2

Switch Power Requirements

Operating voltage requirements are as follows:

90 to 264 Vac; 47 to 63 Hz

59043-01 A 4-1