Q-Logic SANBOX2-64 manual Table B-12. System Configuration Settings

￿				B – Command Line Interface
				Set Setup Command
		Table B-11. SNMP Configuration Settings
	Entry		Description
	TrapCommunity		Trap community password that authorizes an SNMP agent to
			receive traps. This is a write-only field. The value on the switch
			and the SNMP management server must be the same. The
			default is “public”.
	AuthFailureTrap		Enables or disables the reporting of SNMP authentication
			failures. If enabled, a notification trap is sent when incorrect
			community string values are used. The default is "False".

system

Prompts you in a line-by-line fashion to change system configuration settings. Table B-12describes the system configuration fields. For each parameter, enter a new value or press the Enter key to accept the current value shown in brackets.

Table B-12. System Configuration Settings

Entry	Description
Eth0NetworkAddress	Internet Protocol (IP) address for the Ethernet port.
Eth0NetworkMask	Subnet mask address for the Ethernet port.
Eth0GatewayAddress	IP address gateway.
Eth0NetworkDiscovery	Boot Method (1 - Static, 2 - Bootp, 3 - DHCP, 4 - RARP)
AdminTimeout	Specifies the amount of time in minutes the switch waits
	before terminating an idle Admin session. Zero (0)
	disables the time out threshold. The default is 30, the
	maximum is 1440.
SecurityEnabled	Enables or disables the enforcement of account names
	and passwords.
LocalLogEnabled	Enables or disables the saving of log information on the
	switch.
RemoteLogEnabled	Enables (True) or disables (False) the recording of the
	switch event log on a remote host that supports the
	syslog protocol.
RemoteLogHost IPAddress	The IP address of the remote host that will receive the
	switch event log information.

59043-01 A B-41