B – Command Line Interface

￿

Set Config Command

threshold

Initiates a configuration session by which to generate and log alarms for selected events. The system displays each event, its thresholds, and sampling interval one line at a time and prompts you for a value. For each parameter, enter a new value or press the Enter key to accept the current value shown in brackets. These parameters must be saved in a configuration and activated before they will take effect. Refer to the ”Config Command” on page B-7for information about saving and activating a configuration. Table B-9describes the Set Config Threshold parameters. The switch will down a port if an alarm condition is not cleared within three consecutive sampling intervals (by default 30 seconds). An alarm is cleared when the threshold monitoring detects that the error rate has fallen below the falling threshold.

Table B-9. Set Config Threshold Parameters

Parameter

 

Description

 

 

Threshold Monitoring Enabled

Master enable/disable parameter for all events.

 

Enables (True) or disables (False - the default) the

 

generation of all enabled event alarms.

CRCErrorsMonitoringEnabled

The event type enable/disable parameter.

DecodeErrorsMonitoringEnabled

Enables (True) or disables (False) the generation

ISLMonitoringEnabled

of alarms for each of the following events:

LoginMonitoringEnabled

CRC errors

LogoutMonitoringEnabled

Decode errors

LOSMonitoringEnabled

ISL connection count

 

Login errors

 

Logout errors

 

Loss-of-signal errors

Rising Trigger

The event count above which a rising threshold

 

alarm is logged. The switch will not generate

 

another rising threshold alarm for that event until

 

the count descends below the falling threshold

 

and again exceeds the rising threshold.

Falling Trigger

The event count below which a falling threshold

 

alarm is logged. The switch will not generate

 

another falling threshold alarm for that event until

 

the count exceeds the rising threshold and

 

descends again below the falling threshold.

Sample Window

The period of time in seconds in which to count

 

events.

 

 

 

B-30

59043-01 A

Page 136
Image 136
Q-Logic SANBOX2-64 manual Table B-9. Set Config Threshold Parameters