Q-Logic SANBOX2-64 manual Set Config Command, Keywords blade slotnumber, Port portnumber

￿	B – Command Line Interface
	Set Config Command

Set Config Command

Sets switch, port, alarm threshold, and zoning configuration parameters.

Authority	Admin authority and a Config Edit session
Syntax	set config
	blade [slot_number]
	port [port_number]
	ports [port_number]
	switch
	threshold
	zoning

Keywords blade [slot_number]

Initiates an edit session in which to change configured administrative state for an I/O or cross-connect blade occupying the slot given by [slot_number]. If you omit [slot_number], the system begins with slot 1 and proceeds in order through slot

12.Slots 1–4 and 6–9 are I/O blades; slots 11–12 are cross-connect blades. Enter a new value or press the Enter key to accept the current value shown in brackets. Enter “q” to cancel the configuration for one blade, or “qq” to cancel the configuration for all blades.

port [port_number]

Initiates an edit session in which to change configuration parameters for the port number given by [port_number]. If you omit [port_number], the system begins with port 0 and proceeds in order through the last port. For each parameter, enter a new value or press the Enter key to accept the current value shown in brackets. Enter “q” to cancel the configuration for one port, or “qq” to cancel the configuration for all ports. Table B-7describes the port parameters.

ports [port_number]

Initiates an editing session in which to change configuration parameters for all ports based on the configuration for the port given by [port_number]. If you omit [port_number], port 0 is used. For each parameter, enter a new value or press the Enter key to accept the current value shown in brackets. Enter “q” to cancel the configuration. Table B-7describes the port parameters.

Table B-7. Set Config Port Parameters

Parameter	Description
AdminState	Port administrative state: online, offline,
	diagnostics, or down.
LinkSpeed	1Gb/sec or 2 Gb/sec
PortType	Type of port
TLPortMode	Configures a TL_Port for a loop of private target
	or initiator devices.

59043-01 A B-27