SMC Networks 1000BASE-X manual Configuring Port Parameters, See Flow Control in this table

USING THE SYSTEM CONFIGURATION PROGRAM

Configuring Port Parameters

Use the Port Configuration menus to set or display communication parameters for any port or module in the stack.

Port Configuration : Unit 1 Port 1 - 12

==================

Flow Control on all ports : [Enable] [Disable]

Port Type Admin Flow Control Speed and Duplex

--------------------------------------------------------

1	100FX	ENABLED	DISABLED	100_FULL
2	100FX	ENABLED	DISABLED	100_FULL
3	100FX	ENABLED	DISABLED	100_FULL
4	100FX	ENABLED	DISABLED	100_FULL
5	100FX	ENABLED	DISABLED	100_FULL
6	100FX	ENABLED	DISABLED	100_FULL
7	100FX	ENABLED	DISABLED	100_FULL
8	100FX	ENABLED	DISABLED	100_FULL
9	100FX	ENABLED	DISABLED	100_FULL
10	100FX	ENABLED	DISABLED	100_FULL
11	100FX	ENABLED	DISABLED	100_FULL
12	100FX	ENABLED	DISABLED	100_FULL

<APPLY> <OK> <CANCEL> <PREV UNIT> <NEXT UNIT> <PREV PAGE> <NEXT PAGE> Use <TAB> or arrows keys to move. <Space> to scroll options.

Parameter	Default	Description
Flow Control	Disabled	See “Flow Control” in this table.
on all ports
Type		Shows port type as:
		100FX	: 100BASE-FX
		1000SX	: 1000BASE-SX
		1000LX	: 1000BASE-LX
		1000T	: 1000BASE-T
Admin	Enabled	Allows you to disable a port due to abnormal behavior
		(e.g., excessive collisions), and then re-enable it after
		the problem has been resolved. You may also disable
		a port for security reasons.

2-30