CONFIGURING THE SWITCH
Configuring STA for Ports
The following figure and table describe port STA configuration.
Spanning Tree Port Configuration : Unit 1 Port 1 - 12
================================
Fast forwarding on all ports | : [Enable] | [Disable] | ||
Port | Type | Priority | Cost | FastForwarding |
1 | 100FX | 128 | 19 | ENABLED |
2 | 100FX | 128 | 19 | ENABLED |
3 | 100FX | 128 | 19 | ENABLED |
4 | 100FX | 128 | 19 | ENABLED |
5 | 100FX | 128 | 19 | ENABLED |
6 | 100FX | 128 | 19 | ENABLED |
7 | 100FX | 128 | 19 | ENABLED |
8 | 100FX | 128 | 19 | ENABLED |
9 | 100FX | 128 | 19 | ENABLED |
10 | 100FX | 128 | 19 | ENABLED |
11 | 100FX | 128 | 19 | ENABLED |
12 | 100FX | 128 | 19 | ENABLED |
<APPLY> <OK> <CANCEL> <PREV UNIT> <NEXT UNIT> <PREV PAGE> <NEXT PAGE>
other keys to make changes.
Parameter | Default | Description | |
Fast forwarding | Enabled | See “FastForwarding” in this table. | |
on all ports |
|
|
|
Type |
| Shows port type as: | |
|
| 100FX | : |
|
| 1000SX | : |
|
| 1000LX | : |
|
| 1000T | : |
Priority | 128 | Defines the priority for the use of a port in the STA | |
|
| algorithm. If the path cost for all ports on a switch are | |
the same, the port with the highest priority (i.e., lowest value) will be configured as an active link in the Spanning Tree. Where more than one port is assigned the highest priority, the port with lowest numeric identifier will be enabled. The range is 0 - 255.
