SMC Networks 1000BASE-X manual Upgrading Firmware VIA the Serial Port

UPGRADING FIRMWARE VIA THE SERIAL PORT

3.Change your baud rate to 115200 bps, and press Enter to enable download mode. From the terminal emulation program, select the file you want to download, set the protocol to XModem, and then initialize downloading.

Notes: 1. If you use Windows HyperTerminal, disconnect and reconnect to enable the new baud rate.

2.The download file should be an SMC6924MT binary file from SMC; otherwise the agent will not accept it. The file naming convention is:

Runtime program:	Agent-Vx.yz,
POST program:	Boot-Vx.yx, and
Mainboard program:	8051-Vx.yz

4.After the file has been downloaded, the console screen will display information similar to that shown below. Press “s” to start the management interface, change the baud rate back to 19200, and press Enter. The Logon screen will then appear.

XModem Download to DRAM buffer area 0x00200000: ... SUCCESS ! Verifying image in DRAM download buffer 0x00200000... SUCCESS ! Update FlashROM Image at 0x02880000 ... SUCCESS !

(D)ownload another Image or (S)tart Application: [S] s Change Baud Rate to 19200 and Press <ENTER>.

For details on managing the switch, refer to Chapter 2 for information on the out-of-band console interface, or Chapter 3 for information on the Web interface.

A-3