MANAGEMENT SETUP MENU
IP Configuration
Use the IP Configuration screen to set the bootup option, or configure the switch’s IP parameters. The screen shown below is described in the following table.
Network Configuration : IP Configuration
========================================
Interface Type : Ethernet
| IP Address | : 10.1.113.29 |
| Subnet Mask | : 255.255.0.0 |
| Gateway IP | : |
| IP State | : |
<APPLY> | <OK> | <CANCEL> |
Use <TAB> or arrow keys to move, other keys to make changes. | ||
Parameter | Description |
Interface Type | Indicates IP over Ethernet. |
IP Address | IP address of the stack you are managing. The system |
| supports SNMP over UDP/IP transport protocol. In this |
| environment, all systems on the Internet, such as network |
| interconnection devices and any PC accessing the agent |
| module (or running EliteView) must have an IP address. |
| Valid IP addresses consist of four numbers, 0 to 256, |
| separated by periods. Anything outside of this format will |
| not be accepted by the configuration program. |
Subnet Mask | Subnet mask of the switch you have selected. This mask |
| identifies the host address bits used for routing to specific |
| subnets. |
