Release 1.0

CMTS Commands

 

 

cable downstream description

The cable downstream description command is used to specify descriptive information for a downstream port on the BSR. This information is limited to 80 characters and single word descriptions are not allowed. Use the characters: _ or - to separate words. For example, if a downstream port served a certain section of a city, the MSO could assign the following description:

MOT(config-if)#cable downstream 0 description charlestown_1D

Note: The entered description can be seen in the running configuration, and in the command output of show commands such as the show ip interface and show running-configcommands.

Command Mode

Interface Configuration (cable interface only)

Command Line Usage

cable downstream <0-1> description <LINE>

Command Syntax

0-1

is the downstream port number.

LINE

is the text that describes the interface.

526363-001-00 Rev. B

MGBI

11-9

Page 555
Image 555
Motorola BSR 2000 manual Cable downstream description, MOTconfig-if#cable downstream 0 description charlestown1D