Motorola BSR 2000 manual Cable upstream rate-limit

BSR 2000 Command Reference Guide Release 1.0

cable upstream rate-limit

The cable upstream rate-limitcommand controls whether rate-limiting is applied to any CM sending upstream data to the CMTS on a given upstream interface. The no cable upstream rate-limitcommand changes the rate limit applied to a cable modem sending upstream data to the CMTS back to the default which is disabled. The token-bucket algorithm is used for rate-limiting.

Note: If the rate-limit is enabled, data received from cable modems are rate-limited according to the cable modems configured. Packets may be buffered at times when any cable modem or the hosts behind the cable modems transmit data exceeding the permitted bandwidth.

Group Access

MSO

Command Mode

Interface Configuration

Command Line Usage

cable upstream <NUM> rate-limit no cable upstream <NUM> rate-limit

Command Syntax

NUM Upstream port number

Command Default

Disabled

11-102 MGBI 526363-001-00 Rev. B