Release 1.0 | CMTS Commands |
|
|
show cable modem phy
The show cable modem phy command displays the following physical hardware information for or all cable modems attached to the BSR, cable modems on a specific CMTS module, or a specific cable modem:
Mac Address | the MAC address of the cable modem |
I/F | the channel number |
USPwr (dBmV) | the upstream power level in dBmV as |
| measured at the CMTS upstream port for this |
| cable modem |
USSNR (tenthdB) | the estimated upstream signal to noise ratio of |
| signals generated by this cable modem as |
| measured at the CMTS upstream port |
Timing Offset | the ranging time offset for the cable modem |
Mod Type | the modulation type for the cable modem - |
| possible types are: |
| TDMA - DOCSIS 1.X capable modems or |
| DOCSIS 2.0 modems with TLV39 DOCSIS |
| 2.0 Mode disabled |
| ATDMA - DOCSIS 2.0 modems on an |
| ATDMA or MTDMA channel. |
| SCDMA - DOCSIS 2.0 modems on an |
| SCDMA channel |
The following is typical output from the show cable modem phy command:
MGBI |
