Motorola BSR 2000 manual Cable dynamic-service authorization-mode, Authnoecn02064, Authorize

BSR 2000 Command Reference Guide Release 1.0

cable dynamic-service authorization-mode

The cable dynamic-service authorization-mode command allows the cable interface to accept dynamic service. The no cable dynamic-service command rejects dynamic service on the cable interface.

Group Access

All

Command Mode

Interface Configuration (cable interface only)

Command Line Usage

cable dynamic-service authorization-mode {auth_no_ecn02064 authorize disable unauthorize}

Command Syntax

auth_no_ecn02064	authorize Dynamic Service based on DQoS
	gates without PacketCable ECN 2064 support
authorize	authorize CM initiated Dynamic Service
	based on DQoS gates, which only accepts
	DOCSIS DSX MAC management message
	types (DSA-REQ, DSC-REQ, DSD-REQ)
	from the CM that is authorized through
	DQoS. This argument is required when DQoS
	is enabled.
disable	reject all Dynamic Service
unauthorize	accept all Dynamic Service

Note: ECN 2064 (dqos-n-02064) places additional requirements on the authorization of dynamic service requests by an MTA. Set this value if the MTAs connected to the cable interface do not support this ECN.

16-2 MGBI 526363-001-00 Rev. B