Release 1.0

OSPF Commands

 

 

ip ospf transmit-delay

The ip ospf transmit-delaycommand sets the approximate amount of time to transmit an LSA retransmissions for adjacencies belonging to an OSPF interface. The no ip ospf transmit-delaycommand changes the approximate amount of time set to transmit an LSA retransmissions for adjacencies belonging to an OSPF interface.

Use the ip ospf transmit-delaycommand to enable the delay over a link. The delay is defined as the time that it takes for the LSA to propagate over a link.

Before transmission, LSAs in the update packet must have their ages incremented by the amount specified in the seconds argument. The value should take into account the transmission and propagation delays for the interface.

If the delay is not added before transmission over a link, the time in which the LSA propagates over the link is not considered. Significance is greater on low-speed links.

Group Access

ISP

Command Mode

Interface Configuration

Command Line Usage

ip ospf transmit-delay <1-3600>no ip ospf transmit-delay

Command Syntax

1-3600

the time it takes to transmit an LSA in

 

seconds

Command Default

1

526363-001-00 Rev. B

MGBI

8-27

Page 497
Image 497
Motorola BSR 2000 manual Ip ospf transmit-delay 1-3600no ip ospf transmit-delay