Release 1.0 | VLAN Tagging Commands |
|
|
encapsulation dot1q
The encapsulation dot1q command configures tagged routing on a bridge trunk port. This means that all layer 3 packets routed by the BSR that egress the port are tagged with a particular 802.1Q VLAN ID tag. The no encapsulation dot1q disables VLAN tagged routing.
Group Access
All
Command Mode
Interface Configuration
Command Line Usage
encapsulation dot1q <2-4094> no encapsulation dot1q <2-4094>
Command Syntax
the VLAN ID for routed traffic |
Note: VLAN ID 1 is reserved for use by the attached Layer 2 switch/router for management purposes and as the default "native" VLAN for that equipment. VLAN ID 1 may not be configured on the BSR for Ethernet port tagged routing or for cable modem Layer 2 bridging.
The encapsulation dot1q command can be used only if "bridge mode trunk" has already been entered on the interface with the bridge mode trunk command.
MGBI |
