Motorola BSR 2000 manual Apply transport, Bypass, Discard, After

Release 1.0	PacketCable Commands
num	transport protocol number which is the IP
	protocol from the IP protocol header. The
	format is a decimal number. A value of “0”
	represents any protocol. For example, the Call
	Management Server/Gate Controller or Call
	Management Server/Policy Server can use
	TCP Port 6 and the Record Keeping Server
	can use UDP Port 17.
0-65535	source TCP/UDP port number. “0” represents
	any port.
0-65535	destination TCP/UDP port number. “0”
	represents any port
apply transport	used if the packet matches the rule for this
	policy (i.e., ipAddr, ipAddr2, num, source
	port, or destination port matches the packet
	being processed), then apply transport mode
	IPSEC to the IP Packet.
bypass	used if the packet matches the rule for this
	policy (i.e., ipAddr, ipAddr2, num, source
	port, or the destination port matches the
	packet being processed), then the IPSEC
	processing is bypassed and the IP packet is
	processed.
discard	used if the packet matches the rule for this
	policy (i.e., ipAddr, ip Addr2, num, source
	port, or destination port matches the packet
	being processed), then discard this IP packet.
after	allows a rule to be inserted after an existing
	rule in the SPD. If the after is not present, the
	new rule is added to the first index.
num	policy security index number from the show
	ipsec spd policy command. The index
	numbering begins at “1”.

526363-001-00 Rev. B MGBI 16-57