Release 1.0

System Administration Commands

 

 

radius-server source-interface loopback

The radius-server source-interface loopback command allows an operator to

control the source IP address of Radius authentication protocol packets generated by the BSR by specifying a loopback interface as the source IP address for Radius authentication protocol packets. The normal convention for generated Radius authentication protocol packets is to set the source IP address equal to the IP address of the outgoing interface. The radius-serversource-interface loopback command overrides this convention and instead uses the IP address of the specified loopback interface. The no radius-serversource-interface loopback command removes the loopback source interface.

Note: Before using the radius-server source-interface loopback command, the loopback interface must be configured and assigned an IP address.

Group Access

System Administrator

Command Mode

Global Configuration

Command Line Usage

radius-server source-interface loopback <1-64>no radius-server source-interface loopback

Command Syntax

1-64

the loopback interface number

526363-001-00 Rev. B

MGBI

1-101

Page 137
Image 137
Motorola BSR 2000 manual Radius-server source-interface loopback