BSR 2000 Command Reference Guide

Release 1.0

 

 

cable downstream shutdown

The cable downstream shutdown command is used to disable an enabled downstream port when certain downstream parameters require that the downstream port is disabled before these parameters are configured.

The downstream port is disabled by default. Use the no cable downstream shutdown command to enable the downstream port after the required downstream parameters are configured for the BSR. The downstream port is not active for data transmission until it is enabled.

Group Access

MSO

Command Mode

Interface Configuration

Command Line Usage

cable downstream [<0-0>]shutdown no cable downstream [<0-0>]shutdown

Command Syntax

0-0

Downstream port number.

Command Default

The downstream port on the cable interface is disabled or "shut down" by default.

11-20

MGBI

526363-001-00 Rev. B

Page 566
Image 566
Motorola BSR 2000 manual Cable downstream shutdown, Cable downstream 0-0shutdown no cable downstream 0-0shutdown