Release 1.0

PIM Commands

 

 

ip pim query-interval

The ip pim query-intervalcommand adjusts how often PIM router query messages are sent to other PIM routers to control the DR process. IP multicast routers send PIM query "Hello" messages to determine which router is the Designated Router (DR) for each LAN segment (subnetwork). The DR sends Internet Group Management Protocol (IGMP) host query messages to all hosts on the directly connected LAN. When PIM operates in sparse mode, the DR sends source registration messages to the Rendezvous Point (RP). The no ip pim query-intervalcommand sets the PIM router query messages to the default interval; it does not disable the query messages.

Group Access

ISP

Command Mode

Interface Configuration

Command Line Usage

ip pim query-interval <1-65535>no ip pim query-interval

Command Syntax

1-65535

the PIM query message interval in seconds

Command Default

30 seconds

526363-001-00 Rev. B

MGBI

13-5

Page 913
Image 913
Motorola BSR 2000 manual Ip pim query-interval 1-65535no ip pim query-interval