BSR 2000 Command Reference Guide

Release 1.0

 

 

ping

The Packet Internet Groper (PING) ping command sends an Internet Control Message Protocol (ICMP) echo request to a remote host that reports errors and provides information relevant to IP packet addressing.

Use the ping command to check host reach ability and network connectivity, or to confirm basic network connectivity.

Note: The address of the source in an echo message will be the destination of the echo reply message. To form an echo reply message, the source and destination addresses are simply reversed, the type code changed to 0, and the checksum recomputed.

ICMP is used to report problems with delivery of IP datagrams within an IP network. It can also show when a particular node is not responding, when an IP network is not reachable, when a node is overloaded, when an error occurs in the IP header information, etc. The protocol is also frequently used by Internet managers to verify correct operations of nodes and to check that routers are correctly routing packets to the specified destination address.

Group Access

All

Command Mode

User EXEC and Privileged EXEC

Command Line Usage

ping {<A.B.C.D> Hostname}[size <40-65515][<1-65535>] [timeout <1-1024>] [source <A.B.C.D>] [tos <0-255>] [ttl <0-255>] [df]

ping docsis {<mac> <prefix>} <1-100>

Command Syntax

A.B.C.D

IP address of the remote system to ping

Hostname

name of the remote system to ping

size 1-165535

size of the echo message in bytes,

2-40

MGBI

526363-001-00 Rev. B

Page 244
Image 244
Motorola BSR 2000 manual Ping, Hostname