Motorola BSR 2000 manual Show cable modem

Release 1.0 CMTS Commands

show cable modem

The show cable modem command is used to gather a variety of cable modem (CM) statistical information used to evaluate network performance, troubleshoot registration problems, and learn specific registration and ranging information on modems connected to a specific interface.

Use the show cable modem command to see detailed modem configuration information for a specific head-end modem. The following information is provided:

Interface	CM interface with active connection
Upstream IF Index	Upstream interface to which the cable
	modem belongs.
Downsteam IF Index	Downstream interface to which the cable
	modem belongs.
Prim SID	Primary Service Identifier number.
Connectivity State	Describes the connectivity state of a cable
	modem. The table below describes the 20
	cable modem connectivity states
	supported on the BSR.
Timing offset	CM current timing adjustment.
Rec Power	CM receive downstream receive power
	level in units of whole dB to one decimal
	place
IP address	CM IP address
MAC address	Media Access Control layer address

Cable modem connectivity states are as follows:

init(o)	Option file transfer was started.
init(t)	Time-of-day (TOD) exchange was started.
init(r1)	CM sent initial ranging parameters.
init(r2)	CM is ranging.
init(rc)	Ranging is complete.

526363-001-00 Rev. B MGBI 11-171